Exlar Tritex II DC Series, Инструкция по установке и обслуживанию

Страница: 58 / 70

Curtiss-Wright | Tritex II DC Rev. J PN49220 2/8/2016 58
Tritex 60 & 75: 10 in-lbs (0.83 lbf-ft, 1.13 N-m)
4.) If your actuator has an external anti-rotate mechanism, slide the
rod or rods of the anti-rotate mechanism through the front flange
and into the guide bushing or bushings mounted to the rear of
the flange. Position the extending rod so that the wrench flats are
parallel to the long side of the flange. Slide the cross member
assembly of the anti-rotate mechanism over the end of the rod
and onto the wrench flats. Tighten the two screws that clamp the
assembly to the actuator rod.
Procedures for Complete Re-Greasing
Disassembly
Refer to the exploded view on the following page.
1.) Remove the actuator assembly from the machine by
disconnecting the cables, main rod coupling and actuator
mounting bolts or fasteners.
2.) If your unit does not have an external anti rotate assembly, skip
this step. Loosen the two machine screws that clamp the anti-
rotate cross member to the actuator output rod. Slide the anti-
rotate mechanism forward and off the actuator.
3.) Remove the rear tie rod nuts from the back of the actuator.
The end cap houses the Tritex drive and control.
Extreme care should be taken when removing the tie
rod nuts or tie rods so as not to twist or pull on the drive section of
the actuator. Do not disconnect the wiring between the drive and
the actuator. Do not pinch wires when housing is reassembled.
4.) If your actuator does not have a front flange, skip this step. Slide
the front flange forward and off the actuator. The tie rods will
remain attached to the front flange.
5.) When the face plate is removed, the thrust bearing and the open
end of the roller screw internally threaded cylinder (ITC) are
visible. The roller screw can be removed by turning it counter
clockwise and threading it out of the cylinder. It may be
necessary to keep the roller screw cylinder from turning to
remove the screw.
CAUTION