Excalibur AL-1650-EDPB, Руководство по эксплуатации

Страница: 17 / 20

17
installer Programmable Features (cont’d)
“Tach wire” Before this setting is programmed, refer to the “Violet/White wire” section of the
installation manual for proper wiring connection and the Tach Learn Procedure� It will crank the
engine for up to 3 seconds or until a tach signal is detected�
“Data Tach” mode operates just like the “Tach Wire” setting except it takes its reading from the
D2D data port instead of using the Violet/White wire� Before using, make sure this function is sup-
ported by the Databus Interface module�
“Crank Only”
AKA “blind start” is similar to the “Tachless” settings however, it only makes one
start attempt and does not monitor engine running conditions� This is useful for many “push-to-
start” vehicles�
Feature #8 - PinK/whiTE (iGn #2)wire Function
ignition (press “ lock ” button to program) - DEFAULT
Accessory (press “ unlock ” button to program)
Starter (press “ trunk ” button to program)
This feature changes the operation of the unit’s large PInK/WhITE output wire�
This feature
should only be programmed by the installer �
Feature #7 - Starter Cranking Time
0.75 Second (press “ lock ” button to program) - DEFAULT
1.00 Second (press “ unlock ” button to program)
1.5 Seconds (press “ trunk ” button to program)
2.25 Seconds (press “ start ” button to program)
This feature determines the crank time of the 1st start attempt when in “Tachless” mode� If the
engine doesn’t start on the first attempt, it will retry up to 3 more times extending the crank time by
an additional 0�2 second with each attempt��
Feature #9 - Arm, Disarm or Additional Channels
Arm / Disarm (press “ lock ” button to program) - DEFAULT
Arm / Channel 5 (press “ unlock ” button to program)
Channel 4 / Disarm (press “ trunk ” button to program)
Channel 4 / Channel 5 (press “ start ” button to program)
The system has outputs designed for arming and/or disarming a factory-equipped security system.
These wires may be used instead to provide further system outputs, which are remotely operated
by the controller or transmitter� These outputs are in addition to the 2nd channel and 3rd channel
outputs� As shown in the programming assignment, the arm, disarm, channel 4 and channel 5 are
programmable as various combinations� For example, if the disarm output is needed, but not the
arm output, then channel 4 may be made available for use�
Feature #10 Gasoline Or Diesel Engine
Gasoline (press “ lock ” button to program) - DEFAULT
Diesel 15 Sec. Delay (press “ unlock ” button to program)
Diesel 20 Sec. Delay (press “ trunk ” button to program)
Diesel 30 Sec. Delay (press “ start ” button to program)
This feature changes the system’s timing of the ignition and starter output sequence for gas or
diesel engines� gasoline: the starter output will occur 3 seconds after the ignitions turn on� When
in “Tachless” mode, the engine running status is determined 10 seconds after starting� Diesel:
the starter output will occur 15, 20, or 30 seconds after the ignitions turn on (allows for glow plug
warming)� When in “Tachless” mode, the engine running status will be determined 40 seconds
after cranking�