EvoJet B110neo, Руководство пользователя

Страница: 28 / 43

B110neo – B170neo – B220neo – Instructions 6.0
3:LIMITS – Adjusting the evoJet Engine
CAUTION: Do not change any settings in the LIMITS menu unless you know exactly
what effect the respective change will have! Wrong settings can lead to serious
problems during the operation of your jet engine.
30:ENGINE-IDLE
This parameter specifies the idle revolution speed when the throttle is in the idle position.
Recommend values B100: 50.000 rpm
B170: 33.000 B220: 32.000 rpm
31:ENGINE-100%
This parameter specifies the full thrust revolution speed (100 %) when the throttle is in the full
thrust position.
Standard values
B100-100N: 160.000 rpm
B170-180N: 124.000 rpm
B220-220N: 123.000 rpm
If this setting is changed, the INFO parameters 13:EGT-PEAK, 14:FUELPMP-PEAK and
15:RPM-PEAK are cleared.
32:FUELPMP-MAX
This parameter specifies the maximum allowed voltage [V] for the fuel pump.
If this setting is changed, the INFO parameters 14:FUELPMP-PEAK and 15:RPM-PEAK are reset.
NOTE: The value may also be reduced automatically to match the system.
33:THROTTL-UP
This parameter specifies the acceleration/throttle-up time (more thrust) of the engine.
Recommend value: 3 - 4 sec
34:THROTTL-DOWN
This parameter specifies the deceleration/throttle-down time (less thrust) of the engine.
Standard value: 2.0 sec
35:EGT-MAX
This parameter specifies the maximum exhaust gas temperature for the engine control.
Standard value: 790 °C (1454 °F)
36:EGT-OFF
This parameter specifies the exhaust gas temperature for a safety break during the startup.
Standard value: 840 °C (1700 °F)
37:AIRSPEED-MAX
This parameter specifies the maximum allowed airspeed, above which the thrust of the engine is
automatically reduced. To use this function, set 59:AUX-MODE to AIRSPEED (enables the
AIRSPEED-SENSOR [8135]) and maybe set 54:RC2-MODE to AIRSPEED (RC2 switches the
limiting OFF/ON from the Radio). If RC2-MODE = AIRSPEED is not used the limiter is default ON.
Standard value: 250 km/h (155 mph)
This function requires the Airspeed-Sensor (part no. 8135) to be installed. See page 31.
38:ROTOR-MAX
This parameter specifies the propeller/rotor revolution speed for turboprop and helicopter.
28