evertz 5010, Инструкция по эксплуатации

Страница: 24 / 108

Model 5010 Time Code Master Manual
Page 2-2
Revision 3.1.1
INSTALLATION
VITC OUT A:
A BNC connector that contains the PGM INPUT video with vertical interval timecode
inserted. This output is identical to the VITC OUT B output on older style units. On
newer style units when the Bypass relay option is fitted, this output is bypass protected
by a relay in the case of power loss to the unit.
VITC OUT B:
A BNC connector that contains the PGM INPUT video with vertical interval timecode
inserted. On newer style units when the Bypass relay option is fitted, this output will not
be active when the bypass relay is closed (in the case of power loss to the unit.)
2.1.3. Character Generator Connections
VIDEO CHAR GEN INPUT:
A 75 ohm terminated input of program video onto which characters are to
be inserted.
VIDEO CHAR GEN OUTPUT:
A BNC connector which outputs the VIDEO CHAR GEN INPUT video
with characters inserted. This output is also used to display the on screen programming
menu and is normally connected to a video monitor.
2.1.4. Gen Lock Connections
REF VIDEO IN:
A BNC loop used to provide a genlock reference for the 5010’s generator.
2.1.5. Remote Control Connections
PARALLEL:
A 9 pin female 'D' connector used for parallel remote control inputs. On the 5010-24 and
5010-VITC-24 the 6 Hz reference signal is also connected to this connector.
SERIAL:
A 9 pin female 'D' connector used for uploading new firmware and for remote control of
the 5010 from a computer.
2.1.6. Power Connections
LINE
: The model 5010 may be set for either 115v/60 Hz or 230v/50 Hz AC operation. The voltage
selector switch is accessible on the rear panel. The line voltage connector contains an
integral slow blow fuse (and a spare one).
2.2. MOUNTING
The model 5010 is equipped with rack mounting angles and fits into a standard 19 inch by 1 3/4 inch
(483 mm x 45 mm) rack space. The mounting angles may be removed if rack mounting is not desired.
2.3. POWER REQUIREMENTS
2.3.1. Selecting the Correct Mains Voltage
Power requirements are 115 or 230 volts AC at 50 or 60 Hz, switch selectable on the rear panel.
Power should be applied by connecting a 3 wire grounding type power supply cord to the power entry
module on the rear panel. The power cord should be minimum 18 AWG wire size, type SVT marked
VW-1, maximum 2.5 m in length.