evertz 5010, Инструкция по эксплуатации

Страница: 51 / 108

Model 5010 Time Code Master Manual
OPERATING INSTRUCTIONS
Revision 3.1.1
Page 4-17
"
Numeric entry mode must be terminated (GTM will be On steady) before any of the
front panel keys will resume normal operation.
When the 5010 is in the Free run mode, press
GEN HOLD
key (when the Generator is being displayed
on the front panel) to start or stop the generator clock. In the continuous jam sync mode, the generator
will be slaved to incoming code from the reader.
4.5.5. Setting the Generator User Bits
Press the
DISPLAY
key one or more times to display the generator user bits if they are not already
displayed. The display prompt will show
GUB
when user bits are displayed. The
ENTER
and
CLEAR
keys are used in conjunction with the numeric keys to set the generator user bits.
"
When entering user bits data make sure that the generator is programmed for TIME
DATA mode. (See section 4.5.1)
Press the
ENTER
key to recall the last User Bits that you entered into the generator. The display
prompt at the left of the display will blink while data entry mode is active, and the dual functioned keys
are now changed to their numeric values. If you want to re-enter these User Bits press the
ENTER
key
to complete the data entry into the generator.
Pressing any numeric key will clear the previous value and place the new value into the numeric
display, starting at the right. Pressing the
SHIFT
key and the numeric keys 0 to 5 will enter the
corresponding hexadecimal values A to F. Un-entered digits are assumed to be zero. When the
required number of digits are entered, press the
ENTER
key to complete the data entry into the
generator User Bits.
Attempts to enter too many digits will result in the display being blanked. Re-enter the correct value
and press the
ENTER
key. Pressing the
CLEAR
key will cancel the data entry mode without changing
any data.
The numeric keys return to their normal functions when the data entry has been completed by pressing
the
ENTER
key or canceled by pressing the
CLEAR
key. The display prompt will return to its steady
On state when data entry mode has been completed.
"
Numeric entry mode must be terminated (GUB will be On steady) before any of the
front panel keys will resume normal operation.