evertz 5010, Инструкция по эксплуатации

Страница: 23 / 108

Model 5010 Time Code Master Manual
INSTALLATION
Revision 3.1.1
Page 2-1
2. INSTALLATION
2.1. REAR PANEL CONNECTIONS
There are two different versions of the 5010 hardware. Earlier versions have the rear panel layout
shown in Figure 2-1 and later versions have the rear panel layout shown in Figure 2-2. The labels on
the connectors are mostly the same, but many of the connectors have been relocated to better suit the
layout of the new circuit board. The 5010-VITC and 5010-VITC-24 will have all the connections, the
5010 and 5010-24 will be missing the VITC input and output BNCs. Installation and operation of the
two versions is similar except where specifically noted.
Figure 2-1: Rear Panel Layout – Earlier Versions or 5010
Figure 2-2: Rear Panel Layout – Later Versions of 5010
The following sections describe the purpose of the rear panel connectors of the model 5010. Figure
2-1 above shows the rear panel connectors provided on the model 5010. Sections 2.1.1 to 2.1.6
describe the specific signals that should be connected to the model 5010.
2.1.1. Linear Time Code Connections
LTC OUT:
A male XLR connector for output of SMPTE/ EBU linear timecode from the translator.
(Balanced)
LTC IN:
A female XLR connector for input of SMPTE/ EBU linear timecode for the reader.
(Balanced)
2.1.2. Vertical Interval Timecode Video Connections
(Models 5010-VITC and 5010-VITC-24 Only)
READER VITC IN:
A BNC loop used to input video containing vertical interval time code for the VITC
reader.
PGM INPUT:
A 75 ohm terminated BNC for input of program video onto which vertical interval time
code is to be inserted.