Everglades 320 EX, Руководство пользователя

Страница: 109 / 170

109
Exterior Equipment
Aft Seats in Seat Position
Aft Seats Folded
Aft Bench Seats
Your boat is equipped with two aft bench seats.
The seats are designed to fold flush against the
rear of the cockpit when they are not in use. Each
seat is secured in the folded position by a hinged
cockpit bolster that becomes the backrest when
the seats are in use.
To use the seats, swing the bolster up, then pull
the top of the seat toward the cockpit. The bottom
of the seat slides in a track and two side supports
move out with the seat as it folds out. The seat
automatically locks into the seating position when
the cushion reaches the full down position.
To store the seat, pull the seat out slightly as you
raise the front of the seat. The rear supports will
release and slide down in the track as the seat
and side supports fold into the recess. Swing the
bolster up and fold the seat in until it is flush with
the recess. Lower the bolster to secure the seat
in the folded position.
Systems Compartment Access
A hatch in the rear of the cockpit provides access
to the generator, pumps, strainers and other equip-
ment in the systems compartment. The stern bilge
pumps, raw water supply manifold, livewell/baitwell
supply pumps, fresh water and raw water pumps
are among the equipment in this compartment.
The hatch is held open by gas springs and secured
with two rotating compression latches with handles
that store flush with the hatch when it is closed.
The latch handle shafts are threaded to pull the
pawl against cockpit sole, securing the hatch and
compressing the gasket for a more watertight
seal. Always make sure the hatch is closed with
the latches in the secured position and the handles
folded flush before operating the boat above idle
speed.
To open the hatch, release the latches by pulling
the handles out and rotating them counterclockwise
until the latch releases. Then lift the hatch to the
System Compartment Compression Latch
350 EX Systems Compartment Hatch