EMV400S FHD / EMV400SSD Mobile DVR
221
9.
Troubleshooting
If you have problems with the system, run through the following checklist to see if you can solve
the problem.
The mobile DVR will not go into record mode.
Bring up the mobile DVR’s Menu and check under the Camera Menu. Verify that all
connected cameras are checked as “Installed” and that Record Mode is set to
“Continuous”.
Check the Storage or Information Menus and verify that the internal storage is being
detected.
The mobile DVR displays nothing on the main monitor.
Make sure the monitor is connected to either BNC Main Monitor port or the VGA port. If
the monitor has multiple inputs, make sure it is on the correct input source and display
setting (1024x768).
Check that the monitor cables are good and power is on.
Verify the recorder is getting the correct supply power.
There is no display coming from one of the channels on the mobile DVR.
In the mobile DVR’s Camera Menu, make sure that all cameras are checked as “Installed”
and unchecked for “Covert”.
If there is still no picture, switch ports or connect a working camera to the port that has no
picture. If you get an image, the problem is coming from the camera or cable.
I cannot connect to the recorder via the internet.
Check that you can connect to the mobile DVR on the LAN.
Check that the mobile DVR has a static IP address and the port used by the mobile DVR is
forwarded correctly to that IP address in the router.
Verify that your Internet Service Provider does not block the IP port being used
Make sure you are using the correct WAN IP address given by the ISP, or, if you have a
Dynamic IP, check if the IP address has changed; use DDNS to avoid problems caused by
changing ISP addresses.
Chapter
9
