Eventide H9, Руководство пользователя

Страница: 36 / 52

H9 User Guide System Mode
33
[BYPTYP] – Choose Bypass Type (DSP, RELAY, DSP+FX)
Press the HOTKNOB button to select. Turn Knob to select DSP, RELAY or DSP+FX.
When [DSP] is selected, Bypass sends the audio at the DSP’s inputs directly to the outputs
without any effects processing.
When [RELAY] is selected, Bypass employs a pair of relays to “hardwire” the inputs to the
outputs, giving a “true bypass.”
When [DSP+FX] is selected, Bypass sends the audio at the DSP’s inputs directly to the outputs
with the decaying ‘tail’ of the current effect mixed in.
Press the PRESETS button once to back-up one level to BYPASS menu.
Press the PRESETS button twice to go to top level System menu.
[KILDRY] – Kill Dry Audio (NO, YES)
Press the HOTKNOB button to select. Turn Knob to enable/disable [KILDRY].
When [KILDRY] is enabled (YES), the dry signal is removed from the output and the H9 only
outputs a 100% wet level. For some of the Presets the Intensity control acts as a Wet/Dry Mix
control. For these Presets, if [KILDRY] is YES, the Intensity control is disabled.
Press the PRESETS button once to back-up one level to BYPASS menu.
Press the PRESETS button twice to go to top level System menu.
[AUX SW] – Program Auxiliary Switches
Up to three Auxiliary Switches can be assigned as controls for the Preset parameters and
system control. The three Aux Switches are connected to the rear panel ¼” stereo phone jack
labeled EXPression Pedal. The H9 detects closures by sensing whether the [TIP], the [RNG]
(ring) or both the tip and ring are grounded [T+R]. Note that you must use a stereo phone
plug when connecting Aux Switches.
If the Expression pedal is in use, only the [RNG] switch is available. See [EXPTIP] for more
information. A Y-lead will be required for this combination as they connect to the same
socket.
To assign the Aux Switches, first press the HOTKNOB button to select [AUX SW]. You will see
two fields (split display) of the display (left/right) showing Parameter destination and Control
source assignments. The Left Footswitch LED is flashing (if it’s not, press the Left Footswitch
to select this field) showing this to be the selected field for editing. Note that the selected side
of the display is flashing.
To assign the switches, first select the H9 function (the destination on the left side of the
display) that you want to externally control (e.g. KB0) and then select the Aux Switch that you
want to control it with (the source).