H9 User Guide
HOTKNOB & Expression Pedal
23
HOTKNOB
The HOTKNOB is like an on-board Expression Pedal. It can be patched to control one or any of
number of parameters simultaneously. The HOTKNOB patch is identical to the Expression
Pedal patch – they work in parallel.
Press the HOTKNOB button to use the Knob. [HOT] is briefly displayed followed by the
parameter name if a single parameter is assigned (e.g. [MIX]) or [HOT+] if multiple
parameters are assigned.
Tip: H9 Control’s Ribbon also works in parallel with the HOTKNOB and Expression Pedal.
Program one and you’ve programmed all three.
Creating a HOTKNOB Patch
To enter HOTKNOB patch mode - press and hold the HOTKNOB button for 2 seconds. The
HOTKNOB LED will blink at a slow rate to let you know you are in the HOTKNOB patch mode.
Once you are in the HOTKNOB patch mode Press the X, Y, or Z parameter button to select the
parameters you want to assign to the HOTKNOB.
When the selected parameter’s name is displayed Press the HOTKNOB button to set the
minimum value [MINVAL]. Turning the Knob will update the display with the parameter value
to be assigned as the [MINVAL] for this parameter's HOTKNOB patch. When you stop turning
the Knob the display will revert to [MINVAL] and alternately flash between MINVAL parameter
name and the current MINVAL parameter value.
Press the HOTKNOB button again to set the maximum value [MAXVAL]. Turning the Knob will
update the display with the parameter value to be assigned as the [MAXVAL] for this
parameter's HOTKNOB patch. When you stop turning the Knob the display will revert back to
[MAXVAL] and alternately flash between [MAXVAL] parameter name and the current
[MAXVAL] parameter value.
Pressing the HOTKNOB switch again will display the current parameter's name.
Press the X, Y, or Z parameter button to select additional parameters to assign to the
HOTKNOB.
Note: The terms [MINVAL] and [MAXVAL] actually refer to the values at the counterclockwise
and clockwise extremes of the Knob’s travel. In other words, it is possible to set the [MINVAL]
to 100msec of delay (for example) and the [MAXVAL] to 1msec of delay.
Note: Changing the HOTKNOB patch will also change the Expression Pedal patch - they’re
one and the same.
Exit HOTKNOB Patch Mode
To exit HOTKNOB patch operation Press and Hold the HOTKNOB button for 2 seconds. The
HOTKNOB button LED will light solidly and the display will show the name of the parameter
assigned the HOTKNOB if a single parameter is patched. If multiple parameters are patched
[HOT+] is displayed. The Edited LED is lit to show that preset is modified but not saved.
Содержание H9
Страница 1: ...H9 Harmonizer User Guide ...