H9 User Guide
Setting Levels
14
Input and Output Swell
The expression pedal can be used to give a volume swell, either before or after the effect. This
can be enabled either
globally
, meaning it is active all the time, or on a preset by preset basis.
You might want to use it before the effect to disconnect or reduce the input, and listen to the
effect die away, whereas after the effect it can be used as a volume control or to perform
fadeouts. This swell is normally used for expression purposes, and only reduces the volume - it
does not boost it.
You may want to disable any pedal or HOTKNOB parameter settings if you are using swell.
This will be done automatically if using Global Swell.
To set the Swell value globally, see System Mode. If a Global Swell is active, the option of
selecting it for presets will not be available.
Note that in Pre/Post and Wet/Dry Routing modes, Swell only affects the Wet channel.
Input and Output Swell are not active when the unit is Bypassed. The Swell values are reset to
maximum when a new preset is loaded.
Enabling/disabling Input Swell
Press and hold the Left Footswitch as described above. The display will show the
Output Level.
Press the HOTKNOB once. The display will show ISW.OFF (default) or ISW.ON.
Turn the Knob to set it to ON or OFF as desired.
Release the Footswitch - the Preset will return to its previous Active or Bypassed
state.
Remember to save the preset, or the change will be lost.
Enabling/disabling Output Swell
Press and hold the Left Footswitch as described above. The display will show the
Output Level.
Press the encoder until the display shows OSW.OFF (default) or OSW.ON.
Turn the encoder to set it to ON or OFF as desired.
Release the Footswitch - the Preset will return to its previous Active or Bypassed
state.
Remember to save the preset, or the change will be lost.
Содержание H9
Страница 1: ...H9 Harmonizer User Guide ...
