For
ward-Facing
39
To access the Lower Anchor Connector Assembly, you
will first need to remove the Lower Anchor Connectors
from its storage location (see pg. 24).
(Illustrations below show pad off for clarity only)
To install this child restraint properly in the forward-
facing position, the Lower Anchor Connector (UAS)
Assembly
MUST
be in the forward-facing belt path.
If the Lower Anchor Connector strap is in the rear-facing
belt path, follow these steps:
• Raise the headrest to its
highest level (pg. 65).
• Lift the headrest pad up
and out of the way (pg.
57).
• Lift the seat pad off the
front of the base.
• Pull the Lower Anchor
Connector strap to the
center of the seat.
• Route the Lower Anchor
Connector strap out
through the forward-facing
belt path.
• Reattach the seat pad.
IMPORTANT:
Make sure
the Lower Anchor Connector
strap does not interfere with
the internal harness straps.
NOTE:
After moving the
Lower Anchor Connector
strap, make sure the strap lies
flat against the seat shell. You
may have to twist the strap to
achieve this.
Moving Lower Anchor Connector
Assembly to Forward-facing Belt path
Forward-facing Installation with
Lower Anchor (UAS) Connectors