Rear-facing
27
To access the Lower Anchor Connector Assembly, you
will first need to:
• Loosen internal harness straps (pg. 70);
• Remove Lower Anchor Connectors (pg. 24);
• Lift pad off front edge of child restraint. (pg. 78).
To install this child restraint properly in the rear-facing
position, the Lower Anchor Connector Assembly
MUST
be in the rear-facing belt path.
(
NOTE:
illustrations below show pad off for clarity only)
Your car seat comes with the Lower Anchor
Connector assembly installed in the rear-facing
belt path.
If the Lower Anchor strap is in the forward-facing belt
path, follow these steps:
• Lift the seat pad off of the
front from the base.
• Pull the Lower Anchor strap
to the center of the seat.
• Route the Lower Anchor
strap out through the rear-
facing belt path.
IMPORTANT:
The crotch
buckle
MUST
be in the
inner
slot
when the seat is installed
rear-facing
and the lower
anchor (UAS) strap
MUST
be
in front
of the crotch buckle.
IMPORTANT:
Make sure the
Lower Anchor Connector strap
does not interfere with the internal
harness straps.
NOTE:
After moving the Lower
Anchor Connector strap, make
sure the strap lies flat against the
seat shell. You may have to twist
the strap to achieve this.
Moving Lower Anchor Connector
Assembly to Rear-facing Belt Path
Rear-facing Installation with Lower
Anchor (UAS) Connectors
Inner slot
Lower Anchor
(UAS) strap