10
CE - Erklärung
Hiermit erklärt
Euromac BV
, Genemuiden-NL, dass das Produkt
Ölradiator
, Marke
EUROM, Typ RK1507N
bzw.
RK2009N
der
LVD-Richtlinie 2006/95/EC
und der
EMC-Richtlinie 2004/108/EG
, sowie den folgenden Normen oder
sonstigen Normdokumenten entspricht:
EN 60335-1:2002+A1+A11+A12+A2
EN 55014-1 :2006
EN 60335-2-30:2003+A1+A2
EN 55014-2 :1997+A1
EN 50366:2003+A1
EN 61000-3-2 :2006
EN 61000-3-3 :1995+A1+A2
Genemuiden, 18-05-2011 W.J. Bakker, alg.dir,
---------------------------------------------------------------------------------------------------------------
English
Technical data
Type
RK1507N
RK2009N
Supply voltage
Volt/Hz
220-240/50
220-240/50
Maximum capacity
Watt
1500
2000
Settings
Watt
500-1000-1500
800-1200-2000
Number of fins
7
9
Thermostat
+
+
Dimensions
cm
35 x 12,3 x 54,7
42,5 x 12,3/23,5 x 54,7 cm
Weight
kg
7.1
8.6
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible damage. Do not use a damaged
heater, but send it back to your dealer for replacement.
3. This heater is strictly intended for normal domestic use. Only use it as an additional heater in your home.
4. This heater in not suitable for use in wet or damp spaces such as bathrooms and laundry rooms. Do not place the
heater in the vicinity of taps, bathtub, shower, pool, fountains or other sources of moisture. Make sure it cannot fall
into water and prevent water from getting into the heater itself. If, at any time, the heater does fall into water, unplug
it immediately! Do not use a heater that has a damp interior but have it repaired. Never immerse the heater, cord or
plug in water and never touch it with wet hands.
5. The supply voltage and utility frequency, specified on the machine, need to match those of the socket that is used.
The electrical installation needs to be protected by a residual current device (max. 30 mAmp).
6. Fully extend the cord before plugging in the heater. Make sure it does not come into contact with any part of the
heater and prevent it from heating up any other way. Do not run the cord underneath carpeting; do not cover it with
mats, carpet strips, or similar and make sure it is not placed in any passageways. Make sure the cord cannot be
stepped on and that no furniture is placed on top of it. Do not lead the cord around sharp corners and do not roll it up
too tightly after use!
7. If possible, do not use an extension cord, as this poses the risk of overheating and fire. If the use of an extension
cord is unavoidable, then make sure it is an undamaged, approved extension cord with a minimum diameter of 3 x
1.5 mm
²
and a minimum permissible power of 1500W (RK1507N) or 2000W (RK2009N). To prevent overheating,
always fully extend the cord!
8. To prevent the circuit being overloaded and fuses being blown, make sure no other appliances are connected to the
same socket or wired to the same electrical circuit as the heater.
9. Do not use the heater outdoors and do not use it in spaces smaller than 6 (RK1507NS) or 9 (RK2009N) m
²
.
10. A heater contains hot and/or glowing and sparking components. Do not, therefore, use it in areas where fuels, paint,
flammable liquids and/or gasses etc. are stored.
11. Do not place the heater near, under, or directly opposite a socket and do not place it near an open fire or other heat
source.
