13 Maintenance, cleaning, testing the stove
All cleaning and inspections must be carried out when the stove is cold, with the plug disconnected,
using gloves and mask. The ZF company does not assume civil or criminal liability, in case you clean
or test the stove when this is on, still warm, with the voltage supply switched on and without proper
protective equipment.
Daily cleaning
Brazier Cleaning
The cleaning of the brazier is crucial for the proper operation of the stove; it should be performed
daily before each start. Lift the brazier from its seat, clean the inside of the brazier with a brush by
removing combustion residues and free all the air passages with a screwdriver or a pointed tool (not
supplied with the stove). This operation is particularly necessary when using a pellet of poor quality;
it is also good to check and clean the brazier support, if there are residues inside they should be
removed with a spoon or with a vacuum cleaner. A good cleaning of the brazier ensures good
combustion and, consequently, a high yield of the stove.
Cleaning the combustion chamber and ash drawer
The cleaning of the ash and combustion chamber should be made when the ash reaches the edge of
the same drawer; it is strictly forbidden to
light the stove if the ash goes beyond it. Every
day when you clean the brazier also check if
the drawer is empty. This maintenance must
be done when the stove is cold; it is
prohibited to use water to cool the ash or to
clean the inside of the stove. You can use the
vacuum cleaner, the drawer must be replaced
correctly and get to the bottom and there
should be no residue of ash in front of or
underneath it, if residues are present, it could
be interfering with the closing of the door,
therefore create an air leak in the combustion
chamber.
Cleaning the glass
The glass is self-cleaning and then, while the stove is in operation, a film of air flows along the
surface of the same, taking away the ash and dirt; Nevertheless after a few hours, a grayish flap will
appear and it has to be cleaned at the first shutdown of the stove. The dirt the glass also depends
on the quality and quantity of pellets used. When this is done, always observe if the gray seal around
the glass is in good condition; if you fail to control the efficiency of this seal the operation of the
stove may be compromised. Pellets of poor quality, dirty brazier, may nevertheless cause more dirt in
the glass.
Attention
: in case of broken or damaged glass, do not try to turn on the stove.
Содержание PASUBIO
Страница 1: ...Use and maintenance manual for pellet stove...
Страница 42: ...Below is an example of installation of ducted heater in a home environment...
Страница 43: ...17 Notes...
Страница 44: ...Notes...