EURO AJPI PASUBIO, Руководство по эксплуатации и обслуживанию

Страница: 33 / 45

Alarm that can occur during the working phase of the stove:
Message on the
display
Reason Solution
ALAR
NO
FIRE
The pellet is over. Reload the pellets in the tank
The auger does not load Check that there are no pellet
obstructions
The draught is not enough Check that there are no obstructions in
the flue and air inlet
The fumes probe is broken or
disconnected Call an authorized service
The pellet feed auger is broken Call an authorized service
The fume extractor is broken Call an authorized service
Power failure Turn on the stove again
Alarm that can occur during the ignition phase of the stove:
Message on the
display
Reason Solution
ALAR
NO
ACC
The flame did not ignite Replace the pellet with a higher quality
one, if the problem persists, call the
authorized service
Plug disconnected or faulty Call an authorized service
The flame did not send the fumes
on right temperature within the
prescribed time The pellet is finished, refill the tank,
switch the stove on, if the problem
persists, call the authorized service
The draught is not enough Check that there are no obstructions in
the flue and air inlet
The pellet feed auger is broken Call an authorized service
The fume extractor is broken Call an authorized service
12.10 Remote Control Description (Optional)
The remote allows you to control the following functions:
Pressing the button 1
The temperature is increased from a minimum value of 7 ° C to a maximum value of 40 ° C
Pressing the button 2
Temperature decreases from a maximum value of 40 ° C to a minimum value of 7 °C
Pressing the button 3
It turns on / off the stove
Pressing the button 4
Joker can be matched to a specific function
Pressing the button 5
Power is decreased from a maximum value of 5 to a minimum of 1
Pressing the button 6
Power is increased from a minimum value of 1 to a maximum of 5