ETC Installation Guide
Echo-Echoflex Interface
Echo-Echoflex Interface
Page 14 of 15
ETC
Keycard Input Settings
1:
Use the [SELECT] button to select the Echo input that has a keycard sensor linked to it.
2:
Press and hold the ON and OFF buttons for five seconds, until the Echo input status LED starts blinking
RED.
3:
Tap the OFF button until the input status LED blinks the either red, green, or amber, according to the
setting you will edit. The output status LED indicates the current setting.
4:
Tap the ON button to edit the current setting displayed on the output status bar.
5:
Press and hold the ON and OFF buttons for five seconds to exit and save. The input status LED shall
go solid RED for four seconds, then shut off.
Restore Defaults
If for any reason you need to restore defaults to the Echo-Echoflex Interface, follow these instructions.
1:
Set the Space rotary dial to 16.
2:
Hold the [RECORD/PROGRAM] and [CLEAR] buttons for 10 seconds.
Remove the Interface from DIN
If for any reason you need to remove the Echo-Echoflex Interface from the DIN rail, follow these
instructions.
1:
Disconnect all wiring.
2:
Insert a flat head screwdriver into the clip on top of the interface, slide it straight up, then pivot the
top of the interface off of the DIN rail.
Input Status
LED
Mode
Output Status
1LED
Output Status
2 LEDs
Output Status
3 LEDs
Output Status
4 LEDs
Red
Ingress
Timeout
0 seconds (default)
30 seconds
1 minute
5 minutes
Green
Egress
Timeout
0 seconds
30 seconds
(default)
1 minute
5 minutes
Amber
Action
Inversion
Non-inverted (default) Inverted
N/A
N/A
Note:
If the ON and OFF buttons are not pressed within 10 seconds, the system will exit without
saving.
Note:
When using restore defaults, the linked Unison Echo controller must also be manually
cleared.
