OPERATING INSTRUCTIONS
MD 180i/16 BASIC
MD 180i/16 BASIC CH
11 / 19
GB
Function
Customised setting
Switch-off delay time
The switch-off delay time starts once movement is no longer detected in the
field of detection.
Acknowledgement:
the
red
and
blue LEDs
flash three times.
Extend the switch-off delay time; max. 60 min.
By pressing the button repeatedly, the switch-off delay time can be extended
as follows:
1 x = 15 min. Acknowledgement:
The
blue LED
flashes once
2 x = 30 min. Acknowledgement:
The
blue LED
flashes twice in 5-sec. cycles
3 x = 45 min. Acknowledgement:
The
blue LED
flashes three times in 5-sec.
cycles
4 x = 60 min. Acknowledgement:
The
blue LED
flashes four times in 5-sec.
cycles
PIR sensitivity
Settings:
maximum (100 %), 75 %, 50 %, minimum (25 %)
The sensitivity of the detector for the purpose of detecting movement can be set.
Acknowledgement:
the
red
and
blue LEDs
flash three times.
Detector LEDs ON / OFF
The LEDs in the detector can be switched on or off.
Acknowledgement:
LEDs OFF:
The
blue LED
is switched off for approx. 2 seconds.
LEDs ON:
The
blue LED
flashes three times.
Reset
The remote control settings are reset and the detector uses the manual
potentiometer values.
Acknowledgement:
The
red
and
blue LEDs
flash three times.
12 h ON / OFF
The lighting is switched on or off continuously for approx. 12 hours. If no
movement is detected in the field of detection and the preset switch-off delay
time has elapsed, the detector returns to the previous operating mode
.
Note:
The
“12 h ON / OFF”
mode can only be exited by entering the
programming mode and using the
“Reset”
function.
Acknowledgement:
The
red
and
blue LEDs
flash three times.
