CU-DIN R 4-CH 16 A KNX
CU-DIN R 8-CH 16 A KNX
40 / 54
CU-DIN R 12-CH 16 A KNX
USER MANUAL
Logic connection 1 enable
When enabling this parameter, the logic connection 1 will be in active state. The
logic block 1 will be bypassed when connect 1 (“Con1”) is disabled. That means
channel A will connect directly to logic block 2.
Options:
Disable
Enable
Disable: Disable logic connection 1
Enable: Enable logic connection 1
Function of logic block 1
This logic block allows selection of “AND” or “OR” or “XOR” or “GATE” for
Boolean calculation by user.
Options:
AND
OR
XOR
GATE
AND: Boolean calculation according to “AND” rule.
OR: Boolean calculation according to “OR” rule.
XOR: Boolean calculation according to “XOR” rule.
GATE: “A” passes through logic block 1 to logic block 2 by the value of “Con1”
set to 1.
“A” cannot pass through logic block 1 to logic block 2 until the value of “Con1”
is set to 1, the output of logic block 1 keeps the same state as before
Object value of logic connection 1 after bus voltage recovery
Set the value of logic connection 1 after bus voltage recovery.
Options:
0
1
0: Initialisation logic connection 1 value is 0.
1: Initialisation logic connection 1 value is 1.
Result of logic block 1 inverted
When setting this parameter to YES, the output of connection 1 will be inverted.
Options:
NO
YES
NO: Result of block not inverted.
YES: Result of block inverted.
Enable logic connection 2
Enable this parameter, the logic connection 2 is now in an active state. The logic
block 2 will not function by disabling connection 2 (“Con2”); this means the
output of logic block 1 passes through “Out” directly.
Options:
Disable
Enable
