Estate Swing E-S 1000H Series, Инструкция по эксплуатации

Страница: 29 / 57

E-S 1000H Series Instruction Manual
Control Box & Running Wires
3.3
Control Box Mounting:

The control box can be mounted on a post or fence line.

If you have a dual operator set up, make sure it is located within 45’ of the slave motor.

Allow at least 3 feet of clearance off the ground.
Wiring:
• Protect incoming wires with strain reliefs (not included)
Dual Operation Junction Box:
You will need the following items for this installation:
• Second Junction Box
• Screws
• PVC Conduit
1) Set aside the junction box cover and screws.
2) Drill two holes in the bottom of the junction box
large enough to fit the cables.
3) Mount the junction box within 5 feet of slave opera-
tor.
The junction box can be mounted on a post or a
fence line. Allow at least 3 feet of clearance off the
ground.
4) Insert operator cable and extension cable into the
holes in the bottom of the junction box, and seal with
caulk.
*You may also use a watertight connector and con-
nector nut to secure the cables. Found at your local
hardware store.
6) Insert wires from extension cable and operator ca-
ble into the terminal block connector as seen to the
right.
7) The terminal block may be kept loose or fastened
inside of the junction box.
8) Install and secure cover.
See next page for instructions on running wire under
the driveway.
TIP: If junction box is located in a high mois-
ture area, apply petroleum jelly on to the
terminal block to protect from moisture.