Esaote MyLab XPro75, Начало работы

Страница: 77 / 144

P R E P A R I N G T H E S Y S T E M
MyLab
- G E T T I N G S T A R T E D 4 - 10
Allow approximately two hours for a full bottle of gel to reach proper
temperature.
Error codes The Thermasonic Gel Warmer contains a temperature sensor to consistently
monitor functions and to protect against overheating.
If the temperature sensor is not operating at all, the Heat Indicator Lamp will
blink once every five seconds. If a short circuit occurs, the Heat Indicator
Lamp will blink twice every five seconds. In either circumstance, the heater
will not operate.
Cleaning
The Gel Warmer may be cleaned by using a soft, damp cloth and a mild
detergent or hospital grade disinfectant, such as ProteX™ ULTRA Wipes.
Do not allow the electronic controls to get wet. Do not use an abrasive
cleaner or isopropyl alcohol to clean the Gel Warmer. Do not submerge or
immerse the Gel Warmer in water.
Lifeguard UGW-01 gel warmer
Lifeguard UGW-01 gel warmer supplied by Esaote presents an operation
button to select the desired temperature and LEDs that provide working
information and alarms, if any.
Fig. 4-5: UGW-01 front panel
Operation Button
Press the operation button on the front panel:

shortly (less than 1 second) to change the temperature setting
value between 37°C and 40°C

long (longer than 1 second) to change the gel warmer
between on and off status.