Instalacion_10 v1.2.fm
- 10/1
2
/07
INSTALLATION
58
Installation manual
3
INSTALLING THE ACTUATOR
)
Horizontality of the actuator
O
The actuator must work horizontally: to do
this, the supports must be positioned with a
height difference of 19 mm.
)
Check horizontality using a spirit level.
)
Assembly positions and dimensions
)
For the correct operation of the actuator, it is
essential that the supports are positioned respecting
the dimensions calculated, with regards to the door
and its rotation axis.
O
IT IS VERY IMPORTANT TO RESPECT THE
DIMENSIONS: If the dimensions are not
respected exactly, the spindle will not make the
whole travel, meaning the absorption system
will not work.
,
The dimensions are selected using either the table or
the attached chart. The table indicates some specific
cases, whilst the chart shows all the possible cases.
The assembly dimensions depend on the opening angle
of the door and the following factors:
•
Type of actuator chosen: short (spindle travel =
265mm) or long (spindle travel = 400mm)
•
Opening of the door inward or outward.
Hence there are four different cases, as explained below
(each case is represented by way of its corresponding
diagram, table and chart).
