Use and maintenance manual
Automatic die cutter
Model: DC-200
____________________________________________________________________________________________________________________
P a g . 2 2
Periodically move the polypropylene base 2 or 3 mm. to even out the wear
Turn or change the polypropylene table when the surface is impaired, to do this, turn off the
machine and loosen the knob displacement.
After this, open the door and replace this table for a new one.
Empty out the water and clean the air intake filter basin if there is condensation in the line.
-
Troubleshooting
The board does not turn on.
Check whether the switch LED turns red to determine a possible problem in the electric power
line to the machine.
The head does not move at all.
Check that the cylinder is upward and that the grid (cylinder cutting detector) is on.
The head moves but does not cut.
Check that the electro-valve is working, and that the connector LED is on.
Check that the regulator pressure is above 2 bar.
Check that the cutting time is programmed between 05 and 10.
The belt is not cut across the full width.
Check that the intake pressure does not drop during cutting due to compressed air supply
shortage.
Check the thickness of the polypropylene plate.
