Use and maintenance manual
Automatic die cutter
Model: DC-200
____________________________________________________________________________________________________________________
P a g . 2 0
Once the first cut is complete, we note that the head will be positioned at point 0 of the opposite
end of the control board. On reaching that point, we release the belt by pressing the raise bar
button.
We place the second end of the belt on the right side, by the right diagonal guide and with the
coverage also on top, and position the far end of the belt just at the O Ref. mark, to pencil the
measurement mark to insert the material, that will be 80x10 70º.
We then insert the material till the mark aligns with 0 Ref. and lower the tread bar and press
START.
Changing die head
WARNING:
When changing the die, it is recommended to turn off the equipment with the OFF switch
for greater safety.
We open the rear door.
We loosen the 2 bolts using a 13mm Allen key.
