Use and maintenance manual
Automatic die cutter
Model: DC-200
____________________________________________________________________________________________________________________
P a g . 1 3
We lower the tread bar using the down push button and press START.
Once the operation is completed, we release the material by raising the tread bar.
DIE CUTTING A-A Finger over finger
NOTE: For this type of die cutting, one requires prior separation of the fabrics with the ply
separator device PS-15
Separate the fabrics of the 130 mm. belt at both ends.
We mount the 50x20 mm die.
We check that the A-A function is activated.
We program STEP 20 mm. and the required width in centimetres.
We shall regulate the pressure to 3 bar, as the cutting pressure is less due to the length of the
blades.
We place the first end of the belt on the left side, by the guide rail, and place the end of the belt
just on the O Ref. mark.
