Use and maintenance manual
Automatic die cutter
Model: DC-200
____________________________________________________________________________________________________________________
P a g . 1 8
We then place the belt under the holding bar until the mark made matches 0 Ref. and we make
sure it is fully in contact with the guide rail.
We lower the tread bar using the down push button and press START.
Once the operation has ended, we release the material by raising the pressing bar.
DIE CUTTING A-B Diagonal 70º
We select the A-B function if it is not activated.
We mount die 80x10 70º.
We program the STEP to 10mm.
We adjust the cutting pressure to 4 // 6bar
We program the width in centimetres 10% wider than the belt width.
Example: if the belt is 400mm. wide, we will program 44 instead of 40.
We remove de diagonal guide of right side and place in the left side.
