Ericsson ECN320, Руководство пользователя

Страница: 73 / 188

Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
65
Console(config-if)# ip address 10.0.0.37 255.255.0.0
Console(config-if)# exit
Console(config)#
ip default-gateway 10.0.100.1
Console(config)#
exit
The following commands are used to copy the configuration to the start up
file to be used at restart of the switch. This will end the configuration of the
ECN330 switch
Console# copy running-config startup-config
On the ECN330 with EMP (A in fig xxxx) on which the switch extension is
connected to, type:
ecn330 (config)# ecn switch-extension add ecn330-
switch remote-uplink-port 26 ip 10.0.0.37
11.2.2.2 ECN320/ESN310 Switch Connected to an ECN
The uplink port on the ECN320/ESN310 switch must run VLAN 247. All
VLAN 246 must be removed from all switch ports. This configuration must
be done using CLI. Connect to the switch using a console or a telnet con-
nection. The following sequence of commands must be given to change the
VLAN settings:
Console# conf
Console(config)# vlan database
Console(config-vlan)# vlan 247 name intmgm media
ethernet state active
Console(config-vlan)# exit
Console(config)# interface ethernet 1/26
Console(config-if)# switchport allowed vlan add 247
tagged
Console(config-if)# exit
Console(config)# interface ethernet 1/1-26
Console(config-if)# switchport allowed vlan remove
246
Console(config-if)# exit