Ericsson ECN320, Руководство пользователя

Страница: 166 / 188

Command Line Interface
158
1553-CNH 160 0787 Uen PA2 2005-09-23
11.9.1.5 update
This command is almost the same as under normal operation. The only dif-
ference is that it is only possible to use the
enc
parameter value (it is only
possible to update the ENC SW from the fallback CLI). Note that the new
ENC SW must be saved in the ECN before executing the update com-
mand.
Please refer to section on page 11.6.10.15 section on page 145 for more
information about the update. For more information about how to upload
SW files please refer to the
ECN330 Installation Guide or the ECN320 In-
stallation Guide .
11.9.1.6 show
Use this command to view the status or log of the ECN (for more informa-
tion about the log files please refer to section 5.3 on page 25).
Syntax
show status
show log [ <lines> ] [ <lines> ]
•
staus
shows the status of the ECN
•
log
prints the log file of the ECN on the screen. The log argument
can be used with two, one or no parameters:
−
Use no parameters to print the whole log file
−
Use one parameter to print the last lines (number of lines
specified by the parameter value
−
Use two parameters to print the log file from the line number
specified in parameter one, to the line number specified in pa-
rameter two.
Default Setting
None
Command Usage
Use this command to view the log file of the ECN. This command is used
for diagnostic purpose in order to identify what went wrong during start up.
Since the log file can be large, specifying the line numbers may be useful.