Operating instruction
Hydraulic system with Motor drive PXD compact
Document no.: B-00021
Edition 2019 09
Operating instruction EN
Copyright by Ergoswiss AG
8/25
3
Preperation for first initial operation
Before commissioning the lifting system, the entire system must be assembled correctly according to the as-
sembly instruction. Commissioning is prohibited until the entire system complies with the provisions of EG
Machinery Directives 2006/42/EG. For this, a risk analysis of the complete system must be carried out so
that you can react to possible residual dangers (for example by constructive measures or by instructions in
the operating instructions and/or by safety instructions on the system).
3.1
Mounting and wiring of the motor
1.
Connect plugs A and B of the motor cable PXD to the motor.
NOTE
Plug
A
must be connected to the motor in a way its cable shows in the direction of the gear
shaft (in the direction of the arrow).
2.
Place both lines of the motor cable into the cable strain relief. The bendable tab of the cable strain
relief should point towards the motor. The distance between cable strain relief and the connectors
A+B should be approx. 140mm.
3.
Firmly compress the cable strain relief while inserting it into the slot of the motor front panel.
A
B
A
B
M1
M2
Motor cable PXD
