Page.
30/55
EXPLANATION:
•
In regime of igniting the fuel is activated module heating element, which is
placed on the right hand side of the burner, the heated air (from the
heating element is delivered in the bottom right side of the burner. The
heating element stops after a preset temperature of the smoke gases is
reached. This temperature is measured by thermo sensor mounted on the
exhaust channel;
•
During first startup of the stove or during a startup after the stove has
stopped, because of lack of pellets, the startup procedure may be repeated ;
•
The stove works according a preset work algorithm realized by specialized
software loaded into the control module. The customer can control and
change some of the parameters ;
•
After the desired air temperature in the room is reached, the controller
automatically switches to a minimum power;
•
During first startup of the stove is recommended to ventilate the premises,
because is possible to accrue unpleasant smell of burning paint );
ATTENTION:
•
During work the door of the stove needs to be completely closed,
otherwise escape of flue gases to the room can occur;
•
During work of the stove, some surfaces get very hot. See figure 4.1.Do
not get burned. Keep the hot surfaces from contact with water or other
liquids, because that can lead to breakage or damage to these surfaces.
The producer is not responsible in cases of not following the safety
requirements or if the stove is used in different way from the way
described from the producer.
5.2.5.
Set up of the stoves parameters
The setup of the work parameters of the stove is done form the menu.
In the next table are shown the work menus which are used for set up of
the stove ant their functionality.
EXPLANATION:
•
By pushing button (3) on the display of the interface module the menus
for control of the work parameters are shown consecutively;
•
“THE HRONOSTAD” Is a weekly timer which controls the stove by
turning it on/off when is programmed;
