Epson TM m30II-SL, Техническое справочное руководство

Страница: 51 / 164

51
Chapter 3 Setup of the Printer
How to Stand the Printer
Follow the procedure below to stand the printer vertically on a table.
Place the printer on a level and flat surface.
1
Turn off the printer.
2
Disconnect the AC cable from the power outlet.
3
Remove the backing sheet from the tape.
4
Attach four pieces of the tape to the bottom of the printer, and then remove another
backing sheet from each tape.
5
Place the printer on the installation surface, and then hold the printer down to secure it.
Make sure to secure the printer using the DF-10 tape. If you just place the printer on a table, the
printer may fall over when it or mounted tablet is pressed hard.
•
The tape is hook and loop fastener. To remove the printer from the installation surface
disengaging the hook and loop fastener tape, apply a force to peel the printer from the surface.
However, if you repeat removing and reattaching the tape multiple times, the tape may become
less cohesive. In such case, replace the tape (DF-10) with new ones.
•
Since four pieces of the tape need to be attached to the printer, you need two sets of DF-10 at a
time.