Epson TM m30II-SL, Техническое справочное руководство

Страница: 50 / 164

50
Chapter 3 Setup of the Printer
5
Attach four pieces of the tape to the bottom of the printer, and then remove another
backing sheet from each tape.
6
Place the printer on the installation surface, and then hold the printer down to secure it.
Placing the Printer Vertically
There are the following two methods to place the printer vertically.
•
Using the optional DF-10 tape, stand the printer on a table.
U
"How to Stand the Printer" on page 51
•
Using the optional OT-WH30SL hanging bracket set, hang the printer on a wall.
U
"OT-WH30SL (Wall Hanging Bracket Set)" on page 78
The roll paper is ejected from the front side, and the roll paper cover opens frontward.
•
The tape is hook and loop fastener. To remove the printer from the installation surface
disengaging the hook and loop fastener tape, apply a force to peel the printer from the surface.
However, if you repeat removing and reattaching the tape multiple times, the tape may become
less cohesive. In such case, replace the tape (DF-10) with new ones.
•
Since four pieces of the tape need to be attached to the printer, you need two sets of DF-10 at a
time.