Epson Stylus Pro 7600 Photographic Dye Ink, Руководство по обслуживанию

Страница: 275 / 322

EPSON Stylus Pro 7600/9600 Revision A
Maintenance Overview 275
6.1 Overview
This section explains necessary maintenance items and their details for this product.
Basically for this product, service technicians are required to visit the user’s location
where the EPSON Stylus Pro 7600/9600 is used, and perform necessary maintenance/
service on-site while following the precautions below. Service technicians have to be
extra careful not to cause any accident to the product or the user’s environment.
W A R N I N G
„
Since the power switch is mounted on the secondary circuit of
the power supply circuit, unless otherwise specified, always
turn off the printer using the power switch. After all moving
parts have stopped, wait several seconds and then disconnect
the power cable from the AC plug socket to prevent electric
shock or circuit damage during service operations.
„
The cover open sensor for detecting the open/close condition of
the front cover has an interlock switch that functions as a safety
device. Therefore, it is prohibited to turn off this switch.
„ A lithium battery is installed on the MAIN Board of this
printer. Be sure to observe the following instructions
when servicing the battery:
„
Keep the battery away from any metal.
„
Do not install the battery in the wrong direction. (This may cause
burning or explosion.)
„
Do not heat the battery or put it near fire.
„
Do not set the C472 MAIN board directly on top of any object
which is conductive.
„
Be careful not to let ink get into your eyes or your skin. If ink
gets in your eye, rinse them immediately with water.
C A U T I O N
„
When performing service and maintenance operations,
sufficient space should be assured surrounding the place where
the work is performed.
„
The printer should be set in a place where there is no vibration,
and where it is level and stable.
„
This machine is extremely heavy, so adequate caution should
be exercised when handling it. (If you are taking or reinstalling
the body and stand, there should be 2 or more persons doing
the work.)
„
If operations are performed which involve the removal of ink
system parts, there is danger of the product or the floor, etc. in
the place where it is installed becoming soiled, so sheets, etc.
should be spread on the floor, etc. during the work o removing
parts related to the ink channels.
„
If you are handling electrical circuit boards, to prevent
destruction of the elements by static electricity, the elements on
the board should not be touched with bare hands. If necessary,
take the necessary measures to prevent static discharge, such as
wearing a ground strap, when performing such work.
„
If you are removing the various covers and operating the
printer in that state, adequate caution should be used so as not
to be injured by high speed operating parts such as the PS fan.
„
The cutter blade is extremely sharp, care should be taken not to
be injured by it.
„
The an ultra-hardened blade is used for the cutter blade, and
materially, this item is extremely brittle, so it should not be
bumped against any metal or other parts on the printer when
handled.
„
If the printer that has already been installed needs to be packed
and transported again, first make certain that the print head
has been capped properly with the power to the printer turned
off. Then remove all the ink cartridges and install all the
packing materials as referred to in the Start-Up Guide or
Assembly and Setup Guide supplied with the printer.