Epson Stylus Pro 7600 Photographic Dye Ink, Руководство по обслуживанию

Страница: 270 / 322

EPSON Stylus Pro 7600/9600 Revision A
Adjustment Mechanism Adjustment 270
5. Slide the CR Unit onto the cutter positioning jig, shift the Paper Guide L up or down to
a position where the plate of the Cutter Holder ASSY comes in contact with the
projection in the lower part of the jig, and tighten the screw.
„
For replacement of Cutter Solenoid ASSY:
After completion of the Paper Guide L up and down adjustment, loosen the
four screws securing the Cutter Holder ASSY to the CR Unit, press the front
end of the Cutter Holder ASSY gently against the tool and tighten the four
screws.
(See Figure 5-74)
6. Set the jig at the left end of the Paper Guide L and make the same adjustment and
checking as step 4 ~ 5 above.
7. Move the carriage to around the center and make checking again.
Figure 5-73. Paper Guide L up and down adjustment
Figure 5-74. Cutter Holder ASSY height adjustment
C H E C K
P O I N T
„
In this adjustment, use the cutter positioning jig for exclusive
use with Stylus Pro 7600 / 9600: do not use the cutter
positioning jig designed for any other printer models.
„
The positions where to set the jig for checking and adjustment
should be the right and left ends as close to the frame as
possible.
At any position where the Paper Guide L is not supported, the
adjustment can not be made properly because of a deflection of
the Paper Guide L.
„
After successful completion of the adjustment above, proceed to
the next item
“Paper Cutting Position Check” (p.271) .
Cutter positioning jig
Projection
Plate of Cutter
Holder ASSY
Cutter positioning jig
Cutter Holder ASSY
Cutter Holder securing screws x4