Epson Stylus Pro 7500, Руководство по обслуживанию

Страница: 55 / 274

EPSON Stylus Pro 7500 Revision A
Product Description Jumper Settings 55
1.11 Jumper Settings
The standard settings for the jumpers/DIP-Switches on the main board (C299MAIN) are as
shown below.
1.12 Maintenance/ Service Calls
There are two types of errors which it is necessary for a service man to check and respond
to, as shown below.
• Maintenance Call n n n n
• Service Call n n n n n n n n
1.12.1 Maintenance Call
Some of the mechanical units used in this printer have counters which count down the
remaining service life based on the proper service life for each unit, and when the
predetermined value is reached, a “Maintenance Call nnnn” message is displayed. If this
message is displayed, it indicates that the end of the service life of the affected unit is
nearing, so it is necessary to replace the affected unit as soon as possible.
If this message is displayed, the “Print?” or “Printing” display message is replaced with the
“Maintenance Call nnnn” message, and after replacing the affected part, it is not cleared
but continues to be displayed until the counter is cleared.
Table 1-44. Jumper Settings
No. Setting
JP1 Short
JP2 Short
SWD1 1 ON
SWD1 2 OFF
C A U T I O N
n
The above jumper settings are used only when making settings at
the factory. they should not be changed during servicing. These
jumper settings determine matching between the firmware, CPU
and ASIC, etc., so if they are changed needlessly, the printer will
not operate.
n
When installing the ASP board, the DIP-Switch settings should be
changed as shown below.
• DIP Switch SettingDIP SW1DIP SW2
• ASP BoardOFF OFF
•When Circuit Board is InstalledONOFF
C A U T I O N
The maintenance and service calls explained here are special functions
for service and support, and public disclosure to the end user is
prohibited.
Table 1-45. Maintenance Call / Code List
Error Code Error Content
0100
o
Waste ink pad service life (less than 1% of capacity
remaining) (for treatment, see concerning the procedure
when the previously mentioned “Service Call” is issued.)