Epson Stylus Pro 7500, Руководство по обслуживанию

Страница: 236 / 274

EPSON Stylus Pro 7500 Revision A
Maintenance General Maintenance Issues 236
6.1 General Maintenance Issues
This section explains necessary maintenance items and their details for this product.
Basically for this product, service technicians are required to visit the user’s location where
the EPSON Stylus Pro 7500 is used, and perform necessary maintenance/service on-site
while following the precautions below. Service technicians have to be extra careful not to
cause any accident to the product or the user’s environment.
.
W A R N I N G
n
Since the power switch is mounted on the secondary circuit of the
power supply circuit, unless otherwise specified, always turn off
the printer using the power switch. After all moving parts have
stopped, wait several seconds and then disconnect the power
cable from the AC plug socket to prevent electric shock or circuit
damage during service operations.
n
The cover open sensor for detecting the open/close condition of
the front cover has an interlock switch that functions as a safety
device. Therefore, it is prohibited to turn off this switch.
n
A lithium battery is installed on the MAIN Board of this
printer. Be sure to observe the following instructions when
servicing the battery:
n
Keep the battery away from any metal.
n
Do not install the battery in the wrong direction. (This may cause
burning or explosion.)
n
Do not heat the battery or put it near fire.
n
Do not set the C299MAIN board directly on top of any object which
is conductive.
n
Be careful not to let ink get into your eyes or your skin. If ink gets
in your eye, rinse them immediately with water.
C A U T I O N
n
When performing service and maintenance operations,
sufficient space should be assured surrounding the place where
the work is performed.
n
The printer should be set in a place where there is no vibration,
and where it is level and stable.
n
This machine is extremely heavy (the body only weighs
approximately 43.5 kg / The body + the stand weighs
approximately 52 kg), so adequate caution should be exercised
when handling it. (If you are taking or reinstalling the body and
stand, there should be 2 or more persons doing the work.)
n
If operations are performed which involve the removal of ink
system parts, there is danger of the product or the floor, etc. in
the place where it is installed becoming soiled, so sheets, etc.
should be spread on the floor, etc. during the work o removing
parts related to the ink channels.
n
If you are handling electrical circuit boards, to prevent
destruction of the elements by static electricity, the elements on
the board should not be touched with bare hands. If necessary,
take the necessary measures to prevent static discharge, such as
wearing a ground strap, when performing such work.
n
If you are removing the various covers and operating the printer
in that state, adequate caution should be used so as not to be
injured by high speed operating parts such as the PS fan.
n
The cutter blade is extremely sharp, care should be taken not to
be injured by it.
n
The an ultra-hardened blade is used for the cutter blade, and
materially, this item is extremely brittle, so it should not be
bumped against any metal or other parts on the printer when
handled.
n
If the printer needs to be transported for any reason, refer to
Chapter 9 of the
Users Guide to put the printer into printer-
transport mode. Also, only use original packing materials and
pack the printer as shown in the
Start-Up Guide or Assembly and
Setup Guide .