Epson Stylus COLOR 3000, Руководство по обслуживанию, Страница: 144 / 180

Troubleshooting
Rev. A
5-16
Condition Cause Checkpoint Solution
Symptom : Abnormal printing (continued)
Vertical lines don’t
align. Bi-
$
is not
properly adjusted.

Perform necessary
adjustments.
(Refer to Chapter 4.)
White banding
problem occurs. The printhead is
defective. Repeat cleaning at least 3 times and
check if the condition is improved.
If not, replace the printhead and run the
Self-test. Replace the printhead.
Paper feed
mechanism does
not operate
normally.

Replace the PF motor.
Outline of the image
is not clear.
Color inks don’t print Head angular is
not properly
adjusted.

Perform necessary
adjustment.
(Refer to Chapter 4.)
properly. Head gap is not
properly adjusted.

Perform necessary
adjustment.
(Refer to Chapter 4.)
Black and color
printheads are not
vertically aligned.

Perform necessary
adjustment.
(Refer to Chapter 4.)
The printhead is
defective.

Replace the printhead.
Symptom : Paper is fed abnormally.
Paper is not fed. Foreign objects
are lodged in the
edge guide, PF
roller, paper guide
unit, or paper
eject drive unit. Turn the knob and check if the paper
feed mechanism is normally
functioning. Remove the foreign
objects.
The PF motor is
defective. Check if the resistance of the motor
coil is as follows;
10
Ω
± 10% at 25 °C per phase
(Refer to Table 5-1.)
Replace the PF motor.
The top edge of the
loaded paper is not
properly positioned. The PF roller
surface has micro
pearl of the glossy
film and doesn’t
grip paper
properly. Check if micro powder is remaining on
the PF roller. Clean the PF roller.
Symptom : The printer detects paper size incorrectly.
The printer prints
beyond the printing
area.
CR PW sensor is
defective. Load the paper and check the Pin 24
and Pin 25 on the CN21 for the change
in the signal HIGH and LOW.
Table 5-11. Repair of M-4I60 Printer Mechanism(continued)