Epson RX595 - Stylus Photo Color Inkjet, Руководство по обслуживанию, Страница: 68 / 131

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Removal of Exterior Parts 68
4. Place the Cables of group A as shown, and connect the connectors to the Main
Board. (Fig. 4-20)
5. Fasten the cables of group A with tape. (Fig. 4-21)
6. Route the harnesses of group B in the order of the power supply harness (CN3)
→
PF Encoder (CN8)
→
CD-R Sensor (CN4), and connect them to the circuit board.
(Fig. 4-21)
7. Connect the FFCs of group C to the connectors, and secure the ferrite core with
acetate tape. (Fig. 4-22)
8. Stick acetate tape on the USB terminal (in the front). (Fig. 4-22)
9. Install the Case Open Sensor Assy. (Fig. 4-14)
Figure 4-20. Routing the Cables of Group A
Figure 4-21. Routing the Cables and FFCs of Group B
Figure 4-22. Routing the cables and FFCs of group C
C A U T I O N
The harness for the Scanner CR Motor (CN17) and that for the
CR Motor (CN14) are provided with the same 2-pin white
connector. Take care not to confuse them when connecting the
connectors to the Main Board.
Stick the acetate tape on the USB terminal (in the front) to cover
both the USB connector and Middle Housing.
Routing the cables of group A
Route here
Route here
CN14
CN7
CN13
CN6
Routing the cables and FFCs of group B
Attachment of CN8 (FFC)
Route the cable of CN4
as shown so it can hold
down the cable of CN3.
Double-stick tape x2
CN3’s route
CN8
CN4 CN3
Double-stick tape x2
Acetate Tape (18x60mm) x2
Be careful about the
wrong side connection
of the terminal.
Routing the cables and FFCs of group C
FFC x5
Acetate Tape (18x20mm)
ferrite core