Epson RX595 - Stylus Photo Color Inkjet, Руководство по обслуживанию, Страница: 56 / 131

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Troubleshooting Troubleshooting When There is No Error Display 56
3.3.4 I/F Related Troubleshooting
This section describes the troubleshooting for the USB I/F and Memory Card Slot.
† USB I/F error
† Troubleshooting for Memory Card Slot
Table 3-13. USB I/F Error
Cause Check Point Remedy
Host PC does not
support Windows
98 essentially.
On Windows, open “My computer”
→
“Property”
→
“Device manager”.
“Universal serial bus controller” is
effective?
Remove the USB driver, and
install it again.
Printer driver is
not installed
correctly.
On Windows, open “My computer”
→
“Property”
→
“Device manager”.
Printer driver is installed in “Other
devices” by mistake?
Delete the driver and install it
again according to operation
manual.
Defective USB
cable Operation is normal if USB cable is
replaced?
Replace the USB cable.
Poor contact
Check to see if there is no adhesion of
foreign matters in the USB interface
connector.
Remove the foreign matters,
and clean the contact.
Defective main
board Check to see if main board is not
damaged.
Replace the main board.
Table 3-14. Troubleshooting for Memory Card
Cause Check Point Remedy
Driver has not
been installed
correctly. Check to see if a memory card
is recognized in the single Assy
mode.
Temporarily remove the driver, and then
install it again.
Data has been
destroyed. Data on card may be destroyed
owing to static electricity. Check to see if card data is read by a
PC. If not, format the card.
A memory card
other than those
specified is used.
Check the card to see if it is one
of the specified cards.
Use a memory card specified.
Memory Card is
faulty. Check to see if another Memory
Card can be recognized.
Use a new Memory Card.
Poor contact.
Check to see if foreign matters
are not adhering to Memory
Card or slot.
Remove the foreign matters, and clean
the contact.
Firmware has
abnormality.
– Upload firmware.
Electric noise, etc.
has been
generated.
Check to see if FFC is
connected correctly and Ferrite
Core is positioned in place
inside the printer.
After the confirmation, if they have no
abnormality, replace the main board.
Defective main
board Check to see if main board is
not damaged.
Replace the main board.