Epson EB-L25000U, Руководство пользователя

Страница: 127 / 231

Submenu Function
s
"Hiding the Image Temporarily (Shutter)" p.100
Advanced : The following items can be set.
•
BNC Sync Termination : Set the termination for the
signal from the BNC port. This should usually be set to
Off . Set to On when analog (75Ω) termination such as for
switchers is necessary.
•
Beep : When this is set to On , the confirmation buzzer
beeps to notify you that the power turns on or off, or
cooling down is finished.
•
Indicators : When set to Off , the projector's indicators are
turned off, except for abnormality or warning.
•
Instant Off : When set to Enabled , the projector goes into
standby status in approximately three seconds after Power
Off. If you turn the power on immediately after turning it
off, command communication may be cut off. To stabilize
command communication, set this to
Disabled . When set
to Disabled , the projector goes into standby status in
approximately 75 seconds after power off.
•
Inv Direction Button : Set this to On when the projector
is installed on a ceiling.
•
HDMI DDC Buffer : If the image from a device
connected using an HDMI extension cable is not
displayed correctly, turning this
On may improve the
image.
•
DVI-D DDC Buffer : If the image from a device
connected using a DVI extension cable is not displayed
correctly, turning this
On
may improve the image.
•
AC Voltage Monitoring : When this is set to On and the
projector is turned off by any method other than pressing
the power button (including direct shutdown), a power
supply voltage warning message is displayed the next time
the projector turns on. If you are using direct shutdown,
set this to
Off
.
Date & Time : Make system time settings for the projector.
s
"Setting the Time" p.38
Lens Calibration : Acquires the information of the lens
installed on the projector.
Submenu Function
A/V Settings
A/V Output : Set this to Always On if you want to output
images to an external device even when the projector is in
standby status.
Monitor Out : Select the image source output to an external
monitor connected to the Monitor Out port when the
projector is in standby status. When set to
Auto , analog
RGB signals from the Computer input port or the BNC
input port are output depending on which source was
selected when the projector was turned off.
Standby Mode If you set Communication On , you can perform the
following operations even if the projector is in standby
mode.
•
Monitor and control the projector over a network.
•
Output audio and images to an external device. (Only
when
A/V Output is set to Always On .)
•
Communication from the HDBaseT port is enabled. (Only
when
Control Communications is set to On .)
a
When monitoring or controlling the pro‐
jector using wireless LAN, set
Connection
Mode to Advanced .
s
Network - Wireless LAN - Connection
Mode p.131
List of Functions
127