Epson 2200 - Stylus Photo Color Inkjet Printer, Руководство по обслуживанию

Страница: 132 / 258

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 132
4.2.4 Removing the ASF Unit
1. Remove the Rear Housing. (Refer to 4.2.1.2.)
2. Disconnect the Connector Cable of the ASF Sensor from the ASF Unit.
3. Remove the two screws 9) C.B.S (P4) 3
×
6 (6
±
1kgf.cm) and one screw 10) CR
mount shaft that secure the Roll Paper Guide and ASF Unit.
Figure 4-23. Screws That Secure the Roll Paper Guide
4. While lifting the Roll Paper Guide and ASF Unit slightly upward as viewed from
the printer rear, slide them to the right to release the three hooks, which secure the
Roll Paper Guide, from the Lower Frame, and remove the Roll Paper Guide and
ASF Unit.
Figure 4-24. Hooks That Secure the Roll Paper Guide
"
The Waste Ink Pads (Small) and the Waste Ink Pads located on
the front right side and right side as viewed from the printer
front are fixed by double-faced tape. When reapplying them,
change the tape if its adhesive force is weak.
Refer to Figure 4-21, "Removing the Waste Ink Pads".
"
When reapplying the Waste Ink Pad Fixing Films, change them
if their adhesive force is weak.
Refer to Figure 4-21, "Removing the Waste Ink Pads".
"
Fit the Ink Tube in the correct position of the Waste Ink Pads.
Refer to Figure 4-22, "Specified Position of the Ink Tube".
Figure 4-22. Specified Position of the Ink Tube
A D J U S T M E N T
R E Q U I R E D
"
When changing the Waste Ink Pads, make the following
adjustment.
•
Protection counter reset
"
Refer to "Chapter 5 Adjustment" for the adjustment
procedure.
Ink Tube
Waste Ink Pads
Roll Paper
Guide
C.B.S(P4)3
×
6
CR Mount Shaft
Connector
C.B.S(P4)3
×
6
ASF
Unit
Hooks