ENVO SNOWBIKE KIT MANUAL
|
VERSION 1.2
42
6.6.3. E X IT G E N E R A L PRO J E C T S E T TI N G
Among the three general project settings, after each setting is completed, if hold button (SW)
long for about 2 seconds, all can exit the setting environment and return to Display 1, meanwhile,
the current set parameters are saved.
Under each setting interface, if there’s no button operation on the meter for more than 1 minute,
and then the meter will automatically return to Display 1, and the original set parameters will be
saved.
6.7. P PA R A M E T E R S E T T I N G
After finishing metric/imperial unit settings, the speed and mileage units stop flashing. Within one
minute after stopping flashing, hold button (UP) and button (DOWN) simultaneously for
about 2 seconds to enter P parameter setting environment.
6.7.1. P PA R A M E T E R D E FAU LT VA LU E S
After finishing each P parameter setting, hold button (SW) shortly to save the current set
values and enter next P parameter setting interface.
6.7.2 . E X IT P PA R A M E T E R S E T TI N G
Among the five P parameter settings, when each parameter setting is completed, if held the
button (SW) long for about 2 seconds, all can exit the setting environment and return to
Display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there’s no button operation on the meter for more than
1 minute, and then the meter will automatically return to Display 1, and the original set parameters
will be saved.
N U M B E R
PAR AMETER NAME
DEFAULT VALUE
P1
Motor Characteristic Parameter Setting Mode
87
P3
Power Assist Control Mode
1
P4
Handlebar Startup Mode
0
P5
Power Monitoring Mode
12
