Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
Page 68 of 73
If using the PWA-2000:
1. Remove the washing compartment from the PWA 2000.
2. Pour the IPA from the pour spout into an IPA recycling container.
3. Wipe down the interior of the washing compartment with a clean paper towel.
If using plastic washing containers:
1. Remove the used IPA from the dirtier bath.
2. Wipe the container clean using a paper towel.
12.2.6
Cleaning Dust
Time needed:
Approximately five minutes
Maintenance frequency:
Weekly
Overview:
Dust may accumulate on, near, or inside of the Envision One. Dust can build up on fans and vent holes.
High levels of dust accumulation can cause the printer to overheat.
IMPORTANT
To protect the internal hardware, the printer automatically shuts down if it reaches the maximum
internal temperature of 49 C/120 F.
Step-by-step:
1. Look around the vent holes on the left and right sides of the printer’s casing for signs of buildup.
2. Listen to the fan for inconsistency, stress, or obstructions when the printer is powered on.
3. To remove dust, power down the printer, disconnect the power cable and then wipe the vents and fan with
a microfiber cloth.
4. After the printer has been cleaned, look down through the safety glass under the material tray to make
sure that there isn’t any dust or debris on the lens.
12.2.7
Power Cycling
Time needed:
Approximately five minutes
Maintenance frequency:
Weekly
Overview:
It is recommended to power cycle the printer under any of the following conditions:
•
the printer is running slowly
•
the printer was recently updated, or
•
the printer has not been powered down in a week
12.2.8
Oxygen Concentrator
Time needed
: Approximately five minutes
Maintenance frequency
: Every two weeks, replace every six months.
Overview:
The oxygen concentrator has a filter located on the base of the concentrator, Fig 5. This filter should be
cleaned every two weeks, and replaced every six months. The oxygen concentrator ships with twelve replacement
filters.
IMPORTANT
Do not attempt this process while the Envision One cDLM is printing!
Step-by-step:
1. In between print jobs, turn off the oxygen concentrator via the power button on the top of the concentrator.
2. Turn the concentrator on its side and locate the filter cap, shown below.
