Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
Page 13 of 73
•
P308+P313 If exposed or concerned: Get medical advice/attention.
•
P404 Store in a closed container.
•
P405 Store locked up.
•
P501 Dispose of contents and container in accordance with local regulation.
IMPORTANT
Do not use other materials than the photopolymers delivered by EnvisionTEC.
Read the relevant Material Safety Data Sheets supplied with the photopolymers before use.
Those components of the photopolymers delivered by EnvisionTEC that have been classified as hazardous do not
have a threshold limit value (TLV). Therefore, it is not necessary to give concrete instructions concerning the TLV.
Please observe the following hint concerning air change:
IMPORTANT
Make sure that the extraction is sufficient. EnvisionTEC recommends an air change of 25 m³/h per
m² effective surface of the laboratory as described in EN 13779.
3.7
Obligations of the Printer Owner
The printer has been produced for commercial use. Therefore:
•
ensure that all general safety regulations and codes of practice as well as the safety measures described
in this manual are observed at all times;
•
observe all environmental regulations when disposing any of the components or consumables;
•
make sure that the Material Safety Data Sheets for the materials used are observed and kept in proximity
to the printer.
3.8
Obligations of the Personnel
Before starting to work, anyone involved in working with/on the printer is obliged:
•
to comply with the basic workplace safety instructions and accident prevention
regulations.
•
to read and follow the safety information chapter and the safety instructions in this instruction manual.
If you still have queries, please contact the manufacturer. See section
3.9
Personnel Qualification
Employees
Activity
Personnel specially
trained for the activity
Trained
operators
Instructed personnel with
specialist training
(mechanics/electrical
engineering)
Transport
X
–
–
Set-Up
–
–
X
Basic calibration tasks
–
X
X
Advanced calibration tasks
–
–
X
Operation
–
X
X
Troubleshooting and fault
elimination
–
X
X
Maintenance
–
X
X
Disposal/Recycling
X
–
–
Legend: X permitted, – not permitted
