Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
Page 11 of 73
IMPORTANT!
This instruction manual must always be kept where the printer is operated! This instruction manual must
be easily accessible for operators and maintenance personnel.
Furthermore, observe:
•
general and local regulations pertaining to accident prevention and environmental protection;
•
the information contained in the supplied Safety Data Sheets.
3.5
Residual Risks
The printer has been constructed according to the state-of-the art and the approved safety regulations.
Nevertheless, the operation of the printer can cause especially the following risks to the health and safety of the
operator or third persons.
Mechanical hazards
•
Risk of hand crushing caused by automatically moving printer parts.
•
Always keep the hood closed when operating the printer. The printer may only be operated if the protecting
devices are working properly.
•
The printer may only be operated by instructed and specially trained personnel. Only execute the
calibration tasks described in this user manual.
For the remaining tasks, have the printer calibrated by trained and authorized service personnel only.
•
Do not try to move the printer yourself.
•
Have the printer transported by trained personnel only.
•
Risk of injury caused by improper handling of the build platform.
Before taking the build platform out, make sure that all persons are clear of the danger zone.
•
Avoid unnecessary movements. Avoid non-ergonomic joint positions.
•
Risk for the operator to slip, stumble or fall. Keep the floor of the printer area clear of loose cables, objects
or liquids.
Electrical hazard
Improper use of conducting components can lead to severe injuries.
Make sure that all conducting components are in good order and condition!
The switch cabinet may be opened by trained and authorized service personnel only.
Particular hazards can be caused by:
•
Incomplete covers or broken parts
•
Improper assembly, incorrect wiring, defective parts etc.
Do not try to set up the printer yourself. Have the printer set up by trained and authorized service personnel only.
UV radiation hazard
WARNING!
Never look directly into the projectors beam!
Looking into the projector with unprotected eyes may cause injury.
Use protective goggles!
Particular hazards can be caused by:
•
Incomplete covers or broken parts;
•
Improper assembly, incorrect wiring, defective parts etc.
UV radiation can damage the skin. Wear safety gloves!
Hazardous substances
Risk to health from photopolymers:
•
Use the appropriate personal protective equipment.
•
Observe the relevant Material Safety Data Sheets supplied with the photopolymers.
Particular hazards can be caused by:
Thermal hazards
