Enterasys X-Pedition XSR, Справочное руководство CLI

Страница: 196 / 684

OSPF Debug and Show Commands
5-120 Configuring the Internet Protocol
show ip ospf neighbor
This command displays the state of communication between this router and its neighbor routers.
Syntax
show ip ospf neighbor [ type number ] [ neighbor-id ] [ detail ]
Mode
EXEC or Global configuration:
XSR>
or
XSR(config)#
Network type OSPF network type. Values can be broadcast, non ‐ broadcast, point ‐ to ‐
point, and point ‐ to ‐ multipoint. Refer to the ip ospf network
command for more information about network type.
Cost OSPF interface cost. This value is either the default or assigned by
means of the
ip ospf cost
command.
Transmit delay Number in seconds added to the LSA age field at the time of LSA
transmission.
State Interface state ‐ not state between neighbors. Valid values: DR, BDR,
Drother, point ‐ to ‐ point, point ‐ to ‐ multipoint, down, backup, loopback.
Priority Interface priority value. Refer to the ip ospf priority command for
more information on priority.
Designated Router id Router ID of the designated router on this subnet if a DR exists.
Interface addr Address of the designated router ʹ s interface to this subnet if a DR exists.
Timer intervals
configured
Refers to the
ip ospf hello-interval
and
ip ospf dead-interval
commands for hello and dead interval values. The wait timer represents
the period that a router waits before initiating a designated router/
backup router election. The wait timer changes when the dead interval
changes. Retransmit timer represents the period between successive
transmissions of LSAs until acknowledgement is received.
Neighbor count Sum of neighbors over the interface.
Adjacent neighbor count Sum of adjacent (FULL state) neighbors on this port.
secondary Specified secondary IP address.
type
Interface type of the selected interface. Valid interface types are
interfaces that exist on this router.
number
Interface number of the selected interface. Valid values correspond to
the number of a particular interface type present on this router.
neighbor-id
Router ID of the neighbor router that the selected port is on.
detail
Displays more data about neighbors including the area in which they
are neighbors, who the designated router/backup router is on the
subnet if applicable, and the decimal equivalent of the E ‐ bit value from
the hello packet options field.