Engl SOVEREIGN 100, Руководство оператора

Страница: 12 / 36

Lead I mode. The red LED to the right of the knob lights up to indicate the Lead I
channel is on.
Determines the Lead II channel's level. Use this knob to adjust the Lead II channel's
volume and dial in the desired balance in comparison with the other channels' levels.
Because this knob is located pre effects loop, it also determines the effects send level in
Lead II mode. The red LED to the right of the knob lights up to indicate the Lead II
channel is on.
Master A volume knob. Located post effect loops, it controls power amp output. The
red LED to the right of the knob lights up to indicate is enabled and
determining the master level. You can also set the master level to 0 via MIDI controller
7. To learn how to do this, see section35 in the chapter.
Master B volume knob. Located post effect loops, it controls power amp output. The
green LED to the right of the knob lights up to indicate is enabled and
determining the master level. You can also set the master level to 0 via MIDI controller
7. To learn how to do this, see section 35 in the chapter.
Remote control via (MIDI) footswitch is a nifty little utility: You can dial in different
levels for and and assign these settings to any channel and mode
that the amp has to offer. This gives you a range of variations that you can program for
different playing styles and musical genres to great dramatic effect. You can use main
channel 1 Clean & Crunch modes for rhythm or cleaner lead lines and the main channel
2's overdriven preamp stage for power chords and soloing, and go from soft to loud at
the touch of a button. You can also broaden the volume and tonal ranges by working
your guitars' volume knob. If your arsenal includes MIDI gear - for instance, the ENGL Z-
15 MIDI Footcontroller - you can use the amp's master volume mute circuit to swiftly
and conveniently set the power amp's level to 0 during short breaks or when switching
axes.
Switches back and forth between the Master A and Master B knobs. The LEDs next to
the knobs light up to indicate which Master knob is active the red LED for , the
green LED for . can also be switched via MIDI program change
or the ENGL Custom Z-9 Footswitch.
Power amp standby switch: Use this switch to silence (0 position) the amp when you
take longer break. The amp's tubes stay nice and toasty, and the amp is ready to roll
immediately when you ramp it back up to full power.
On the one hand, the amp's surveillance system monitors if speaker cords are plugged
Master A
Rear Panel Features
Master B
Rear Panel Features
Master A Master B
Master A
Master B MASTER A/B
A tip from the designer:
28 Stand By
More good-to-know info:
24 Lead II Volume
25 Master A
26 Master B
27 Master A/B
12