Engl SOVEREIGN 100, Руководство оператора

Страница: 18 / 36

wet signal (that is, the processed signal generated by the connected effect device) is
patched to the power amp (serial, 100% wet).
Set this knob to when this loop is not in use!
Connect this FX Loop 2 output to a signal processor's input/return jack using the
shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via
the FX Loop 1/2 (13) button, which switches between these two loops. In the signal
path, is located post preamp and pre the two power amp Master knobs.
Connect this FX Loop 2 input to a signal processor's output/send jack using the
shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via
the FX Loop 1/2 (13) button, which switches between these two loops. In the signal
path, is located post preamp and pre the two power amp Master knobs.
FX mix control for . When the knob is set to , the amp signal is routed
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patched to the power amp (serial, 100% wet).
Set this knob to when this loop is not in use!
Reverb intensity knob. Twist it to adjust the amount of reverb for main channel 1
. Activate (button 14 at the front panel) and twist the Reverb
knob clockwise to increase the effect's intensity. The signal remains completely dry
when the knob set to the 7 o'clock position or (14) is deactivated. The red LED
above this button lights up to indicate is on. In addition, it can be activated and
deactivated via MIDI program change or Custom Z-9 Footswitch.
Reverb intensity knob. Twist it to adjust the amount of reverb for main channel 2's
Lead I and Lead II modes. Activate (button 14 at the front panel) and twist the
Reverb knob clockwise to increase the effect's intensity. The signal remains completely
dry when the knob set to the 7 o'clock position or (14) is deactivated. The red
LED above this button lights up to indicate is on. In addition, it can be activated
and deactivated via MIDI program change or Custom Z-9 Footswitch.
This knob determines the level of the frequency-compensated Line Out (50). Use it to
adjust the amp's line output signal level to match the input gain of the mixing desk or
recorder's input.
NOTE:
42 FX LOOP 2 SEND
43 FX LOOP 2 RETURN
44 BALANCE
NOTE:
47 LEVEL
Dry
FX Loop 2
FX Loop 2
FX Loop 2 Dry
Dry
Clean/Crunch Reverb
Reverb
Reverb
Reverb
Reverb
Reverb
45 REVERB CHANNEL 1
46 REVERB CHANNEL 2
18