10
Eurostar Installation and Operation Manual
2.2 Regulations Covering Pellet Stove Installation
When installed and operated as described in these instructions, this pellet stove is suitable for use
as a freestanding heater in residential installations.
In Canada, the CSA B365 Installation Code for Solid Fuel Burning Appliances and Equipment and
the CSA C22.1 Canadian National Electrical Code are to be followed in the absence of local code
requirements. In the USA, the ANSI NFPA 211 Standard for Chimneys, Fireplaces, Vents and
Solid Fuel-Burning Appliances and the ANSI NFPA 70 National Electrical Code are to be followed
in the absence of local code requirements.
This stove must be connected to a pellet vent system complying with the requirements for Pellet
Vent in the standards UL 103, ULC S629M, ULC S609 and UL 641or to a code-approved masonry
chimney with a stainless steel flue liner.
2.3 Before Operating Your Stove
Some minor installation and adjustment are required prior to use:
•
If desired, LCD sliding support can be installed on the left at the back of the stove; (see
Appendix B:
LCD Sliding Bracket Mounting
).
•
The handle and door must be adjusted; (see
section 8.1.9 Door Adjustment
)
•
The stove must be leveled using threaded legs;
•
The decorative panels must be installed; (Refer to decorative panels instruction sheet)
•
The door overlay must be installed on the door frame as shown:
•
Position the overlay on the door
frame and fix it in place from behind
using the 4 screws.
Note:
It is not necessary to remove
the glass or any other component to
install the overlay.
•
Make sure the fresh air intake back draft shutter works freely.
