EnerSys Alpha Micro 100, Инструкция по установке и эксплуатации

Страница: 10 / 88

9
017-220-J0 Rev C
1.4 Certifications and Compliance
The Alpha Micro 100 has been designed, manufactured, and tested to the requirements of the following national and
international safety standards:
Safety: UL 1778; CSA C22.2 107.3; EN 62040-1* (*applies to 230Vac units only)
EMC: FCC Part 15, Subpart B Class A; ICES-003 Class A; EN 62040-2 Class A* (*applies to 230Vac units
only)
This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
• A battery can present a risk of electrical shock and high short-circuit current. The following precautions should be
observed when working on batteries:
a. Remove watches, rings, or other metal objects.
b. Use tools with insulated handles.
c. Wear rubber gloves and boots.
d. Do not lay tools or metal parts on top of batteries.
e. Disconnect the charging source before connecting or disconnecting battery terminals.
f. Determine if the battery is inadvertently grounded. If inadvertently grounded, remove the source from the
ground. Contact with any part of a grounded battery can result in electrical shock. The likelihood of such
shock can be reduced if the grounds are removed during installation and maintenance (applicable to
equipment and remote battery supplies not having a grounded supply circuit).
• Never let live battery wires touch the Alpha Micro 100 enclosure or any other metal objects. This can cause a fire
or explosion.
• Never dispose of batteries in a fire. The batteries may explode. Follow the manufacturer’s directions and check
with your local jurisdictions for safe battery disposal.
• Before attaching the batteries to the Alpha Micro 100 make sure that the polarity is correct.
• If the batteries have been in storage for more than six months at 25°C, recharge them for at least 24 hours and
then test them with a load before installation.
• Each battery has a date code, found on the warning label, which must be recorded in the maintenance log. If
non-Alpha batteries are used, see the manufacturer’s documentation for date code type and placement.